esigth uses different colors to distinguish different alarm levels, red represents emergency, orange
represents important, and yellow represents
The table is secondary, and blue represents the prompt. Which of the following statements about
different alarm levels is correct: (multiple choice)
A, B, C, D
Explanation:
As shown in the figure, configure a backhaul summary route 10.0.0.0/24 on the border route RT1.
next hop
to RT2. At the same time, the default route to the external network is configured. At this point, a
routing black hole will appear. The following is about routing
Is the black hole statement correct? (multiple choice)
A, C, D
Ethernet is a network that supports broadcasting, and once there is a loop in the network, this
simple broadcasting mechanism can cause catastrophic consequences. Which of the following
phenomena may be caused by loops
A, B, C, D
What characteristics must a high-risk operation plan have?
A, B, C, D
Which of the following reasons may cause the hosts in the same--VLAN LAN to fail to communicate
with each other
A, B, C, D
During the daily troubleshooting process, engineers may need to view some alarm information of
the device. Run the terminal command to enable the terminal to display the debugging/log/alarm
information sent by the information center.
monitor
All routers in a network run IS-IS, and all are in Area 49.0001, where the L SDB of R1 is shown in the
figure
According to this, it is judged that the DIS of Level-2 is. (Please fill in the device name, such as R1)
|<R1> displayisisisdb
DatabaseinformationforISIS (1)
Level-1Link State Database
LSPIDO Seq Num ChecksumbHoldtime Length ATT/P/OL
0001.0000.4004.00-00 0x00000008 0xb701 1186 68 0/0/0
0001.0000.2002.00-00Ox 0000008 0xb701 1186680/0/0
0001.0100.1001.00-00*0x00000050x2f9d1187 680/0/0
0001.0100.1001.01-00*0x00000001 0xa79e1110550/0/0
Level-2 Link State Database
LSPIDAN> Seq Num Checksum., Holdtime Length ATT/P/OL
0001.00002002.00-00 0000000080xb7011188 6S0/0/0
0001.0100.1001.00-00* 0x00000060x2d9e 1187 680/0/0
0001.0100.1001.01-00* 0x00000005OxdObO 1191 660/0/0
0100.0000.3003.00-00 000000005 0xfe53 1185 560/0/0
R1
In the absence of a header, the Domain ID of each OSPF process running on the router and the
process ID of the process
Be consistent and can be modified under the process through the domain-id command
B
The link status information between different S.4S processes of the routers around the Taiwan and
Taiwan is considered to be sound insulation.
A
Senior engineers with rich experience can quickly solve faults only by experience, with high
efficiency.
A
A company purchased private lines from two operators. In order to optimize the lines, the company
used the 6GP protocol to learn from two
Route entries that operate off. However, after the enterprise found that this configuration, the traffic
of the port route increased greatly, and the network engineering arrangement
After investigation, it was found that the traffic of the two operators was passed to each other
through the enterprise egress router. Therefore, the enterprise intends to use the routing strategy so
that the traffic of the packets of different carriers is no longer passed to each other. Is the
configuration in the following figure correct?
A
The routing policy tools that can be used by BGP mainly include Filterpolicy and oRoute-policy.
Fiterpolicy can only filter routes, Rote - policy can only modify routes
B
Explanation:
A campus deploys OSPF to implement network interworking. The LSDB of R2 is shown in the figure.
From this LSDB. it is possible to
What information was obtained?
B, D
Which of the following are static information coke analysis?
A, C, D
According to this diagram, can we break the
B, C